|
|
| 1.
| Remove standard Nissan rubber spoiler from tailgate.
|
| 2.
| Position lower spoiler panel to boat lid and mark around edges.
|
| 3.
| Grind paint from tailgate around bonding area.
|
| 4.
| "Feather" edge of spoiler to blend in with tailgate.
|
| 5.
| Spirit - wipe all bonding surfaces and apply adhesive (UPOL or FILAGAP fibreglass repair paste).
|
| 6.
| Check position of spoiler and secure with small self taping screws and masking tape and allow to set fully.
|
| 7.
| Blend spoiler with tailgate and position wing using self tapping screws supplied.
|
| 8.
| When fiting rear wing, drill through tailgate 1/4" hole between fitting screws. These holes vent the wing.
|
| 9.
| When painted (see painting advice), secure wing to tailgate with screws and adhesive.
|
| 10.
| Leave overnight before high speed driving.
|
|
|
|
|
|
|
