| 1.
| Remove exterior lamps and center panel.
|
| 2.
| Trim metal brackets (see fig. 1).
|
| 3.
| Offer new panel in aperture and check alignment.
|
| 4.
| Clamp panel in position and drill fixing holes. (see fig. 2).
|
| 5.
| Paint panel required colour making sure panel is thoroughly degreased proir to paint application. (see painting advice).
|
| 6.
| Bolt and screw panel in position and mount lamps.
|
| 7.
| Apply "finish seal" by masking line to panel and vehicle body and vehicle body and fill gap with silicone sealer. Wipe smooth, remove masking tape and allow to cure.
|
| 8.
| Wire rear lamps as appropriate.
|
|
|
